Irwin VCA

THE 2164 IC based "MIKE IRWIN" VCA

I was trying to get a simple VCA going using SSM2164s and found I had trouble getting the right exponential response from the chip.

The problem is to get the correct audio response out of the design--one that sounds musical--you have to screw around with the incoming CV signal in some cases. Case in point: My ADSR generates 0 to 5V, and 2.5V should represent (to my ears anyway) 6db, i.e., when the ADSR CV is halfway to ground, So in this case, the VCA's output should half as loud relative to the signal at input. But as the stock 2164 stands, dbs are related to Voltage, at about 30mV per DB. The bottom line is that most unaltered control signal put through the stock circuit seems to fade away much too quickly when controlled by an normal RC based ADSR or equivalent EG circuit if you just feed their outputs into the VCA chip's CV in.

There are several solutions to this problem, and here is one solution by Mike Irwin. His circuit fragment was featured in EDN, and you should read that article here (go to the end of the PDF, pretty much)..... See figure 1 here if you are thinking about using his 2164 circuit. Basically Mike uses one stage of the 2164 to "linearize" the incoming CV, and programs the entire gain structure with a reference input that's below ground. This creates a log to linear response for incoming CV and a really good sounding dual VCA with a very low total parts count (although you also lose 2 of your 4 VCA's on a single 2164--but it's a good tradeoff IMO).

So following this lead I put together a quick little Eagle PCB that has 2 "Mike Irwin" VCAs on a single board, along with provisions for dual CVs per VCA, and some glue components to help setup the REF signal. A zip file of the sch erc etc files is here. (Note, I used to sell copies of this board but don't have any for sale any longer, sorry.)

There are or were other mod synth dudes making or designing this same VCA set up the same way. It might be easier to buy one of their vs. making your own, search for "Irwin VCA" and see what you can find.

Finally, a couple of notes about this circuit. For one: it will work with DC voltages as well as audio; Very useful.

Second: this is a very good performing VCA; quiet and clean.

UPDATE. It seems the SSM2164 isn't available any longer. So this page may be of limited use. I leave it here because I still have a few of the boards and chips around, so this page is useful to may be able to use other VCA's instead, such as the one by THAT: here If anyone has a good source or alternate, please let me know.

UPDATE TO THE UPDATE! Small bear is selling a 2164 clone chip by Cool Audio. I have also found one from Sound Semiconductor here.I haven't tried these but I can't see why it wouldn't work. Long live analog!